The Effect of Frequency and Waveform of AC Excitation on U-Shaped Monopole Plasma Antenna

Document Type : Original Article

Authors

1 BA, Faculty of Electrical Engineering, Tarbiat Debir Shahid Rajaee University, Tehran, Iran

2 Assistant Professor, Faculty of Electrical Engineering, Shahid Rajaee Tarbiat University, Tehran, Iran

3 Assistant Professor, Aerospace Research Institute, Tehran, Iran

Abstract

Today, plasma technology has found significant applications in various industries including telecommunications. The high-ionization limit of plasma has made it a good conductor and a substitute for metal structures in high frequency. In recent years, the plasma environment for the design of reconfigurable antenna structures, waveguides, and frequency-selective surface (FSS) has received more attention by scientific societies, especially space and military centers. This is because of the specific characteristics of the plasma environment that can be used to control and adapt the antenna for different purpose. The effects of plasma usage on the antennas include: Improved sensitivity and Directivity, low Radar Cross Section (RCS), radiation pattern scaning, antenna array coupling and frequency tuning. Plasma can be created with many different ways: excitation with direct current, alternating current, surface wave driven. The purpose of this study was to investigate the effect of alternating current excitation with different frequency and waveform on U-shaped monopole plasma antenna parameters including: reflection coefficient, resonance frequencies and bandwidth. This type of excitation increases the operating frequency of the U-shaped antenna up to 2 GHz and its bandwidth in addition to its much lower power consumption. The signals sent or received from the antenna are applied to or received by a capacitive coupler to the plasma antenna. Also, by changing the frequency and waveform of excitation current (square, triangular, sinusoidal) of plasma, different results on antenna parameters were observed and measured, including: decrease reflection coefficient, central frequency shift and bandwidth change.

Keywords


   [1]      T. J. Dwyer, J. R. Greig, D. P. Murphy, J. M. Perin, R. E. Pechacek, and M. Raileigh, “On the Feasibility of using an Atmospheric Discharge Plasma as an RF Antenna,” IEEE Trans. Antennas Propag., vol. 32, pp. 141–146, 1984.
   [2]      H. Ja’afar, M. T. Ali, H. M. Zali, N. A. Halili, “Analysis and Design between Plasma Antenna and Monopole Antenna,” IEEE International Symposium on Telecommunication Technologies (ISTT 2012), Kuala Lumpur, Malaysia, 27-28 November 2012.
   [3]      T. Anderson, “Plasma Antennas,” Artech House-1 edition, 2011.
   [4]      T. Anderson, “Plasma Frequency Selective Surfaces,” 2014 IEEE Antennas and Propagation Society International Symposium , pp. 2096-2097, 2014.
   [5]      M. A. Lieberman and A. J. Lichtenberg, “Principles of Plasma Discharges and Materials Processing,” New York, Wiley, 1994.
   [6]      Norris, Us Patent No. 5594456, “Gas Tube RF Antenna,” 1997.
   [7]      F. Sadeghikia, M. T.  Noghani, and M. R. Simard, “Experimental study on the surface wave driven plasma antenna,” AEU-International Journal of Electronics and Communications, vol. 70, no. 5, pp. 652-656, 2016.
   [8]      A. Zhu, “Characteristics of AC-biased Plasma Antenna and Plasma Antenna Excited by Surface Wave,” Journal Electromagnetic Analytical and Application, vol. 4, no. 7, pp. 279–284, 2012.
   [9]      C. D. Lorrain and P. Brityei, “Electromagnetic Fields and Waves,” USA 2nd edition, John Wiley& Sons, 1976.
[10]      W. Xiao-Po and Sh. Jia-Ming, “Scattering by Two Parallel Plasma Cylinders,” IEEE International Conference on Microwave and Millimeter Wave Technology (ICMMT), Shenzhen, China, 2012.